Velcro Pads

We are a number plate manufacturer and we used many different sticky pads on the market and found none did the job for us.. So we decided to create our own pads! There are a lot of fake/cheap pads on the market which don’t last long resulting in plates being lost which is dangerous and costly! So we worked with an Automotive German manufacturer to create pads for us that did the job not only for normal plates but also 3D/4D plates which are a lot heavier! 

WHY VELCRO?

With normal pads once you stick them on to your vehicle if you find you have not put them straight and then you have to peel the plate off your pads are ruined and you have wasted your money! Velcro allows you adjust if you’re not happy with the positioning.. Simply remove plate and adjust until you’re happy!

 Normal pads you need to apply around 10 per plate to make it stick making it look tacky! Lush Velcro only require x3 per plate which is more than enough due to the super strength adhesive! 

 Suitable for 3D/4D/Metal plates 

 Lush Velcro pads do not leave residue if you ever were to remove them from your car! Most pads leave nasty white marks which are a nightmare to remove! 

 If you have some show/novelty plates, you can change them over without any issue all you need to do is just buy either rough or smooth set from us and apply to your show plate and just remove and replace! 

WHAT WILL YOU GET

You will receive x6 Lush Rough surface pads and x6 Lush Smooth surface pads, each pad measures 90mm high 50mm wide and only 1mm thick, this kit is for x2 Number Plates.

HOW TO FIT THEM

1) Make sure you clean and dry the number plate and car surface, this is very important to get the best bond

 2) It is very important before you apply pads that you have measured on the vehicle and number plate positioning so they line up when pressing them together, failure to do this will result in plate not getting best bond to the vehicle 

 3) Apply x3 smooth surface pads evenly to your vehicle surface.. Once applied press firmly with your hand to get a good bond 

 4) Apply x3 rough surface pads evenly to your number plate surface.. Once applied press firmly with your hand to get a good bond 

 5) Slowly line the plate up with the vehicle so the pads are facing each other and then press the plate on lightly.. Check to see if the plate is straight. If not, happily remove, adjust and apply again.. Once happy press plate firmly onto vehicle to get a strong bond :0) 

Screw kit

Our screw kit comes with x2 yellow caps x2 white caps with x4 screws. You will require drill to use this fixing kit. We recommend you use a garage/professional to do this. As any damage caused to the plate while drilling will void your warranty. Please do not drill into the letters or near them.

Number Plate holder

Our number plate holders are manufactured in Germany and are very high quality with a simple clip in design. They do not come with screws to fit the holder to your vehicle. They fit only standard size number plates 520x110mm.